Requirements:

• iOS 6 or later
• djay 1.6 or later

Using HDMI via Apple Digital AV adapter

Devices Setup:

• Main Output: Speakers connected to the iPad/iPhone via HDMI cable and Apple Digital AV adapter (e.g. digital TV with speakers, digital audio receiver)
• Pre-cueing: Headphones connected to the iPad's (or iPhone's) headphone jack

Instructions:

1. Plug your headphones into your iPad/iPhone
2. Connect one side of the HDMI cable to the HDMI input of your speaker system and the other side to the Apple Digital AV adapter
3. Plug the AV adapter into your iPad's dock connector
4. Raise the system volume to the maximum by using the volume buttons on your iPad/iPhone
5. Launch djay
6. A window like the one below should appear in djay. Tap "Done" and your good to go! This setup window can also be accessed by tapping the gear icon and selecting "Audio Device Setup".

 
Note: Technically, you could also choose to switch the outputs and use the headphones as main output and the speakers for pre-cueing.
 

Using Griffin iMic via Camera Connection Kit (iPad only)

Devices Setup:

• Main Output: Speakers connected to the iPad via Griffin iMic and Camera Connection Kit (e.g.  any speaker system with Line-in input)
• Pre-cueing: Headphones connected to the iPad's headphone jack

Instructions:

1. Plug your headphones into your iPad
2. Connect your speakers to the iMic's OUT jack
3. Connect iMic to the Camera Connection Kit and plug the Camera Connection Kit into your iPad
4. Raise the system volume to the maximum by using the volume buttons on your iPad/iPhone
5. Launch djay
6. A window like the one below should appear in djay. Tap "Done" and your good to go! This setup window can also be accessed by tapping the gear icon and selecting "Audio Device Setup".

Note: Again, here you could also choose to switch the outputs and use the headphones as main output and the iMic for pre-cueing.


Pre-cueing is not supported in combination with AirPlay or Bluetooth devices.